How to make a rubber Cat-O-nine-Tails

You can be like the cat that got the cream with this rubber Cat-O-Nine-Tails. The cat-o-nine tails is a type of multi-tailed whipping device that originated as an implement for severe physical punishment, notably in the British Royal Navy. However, nowadays whips and floggers are used by couples to enhance sexual pleasure in BDSM games and alike. Spanking the body can make skin more sensitive to touch, because the spanking draws bloody tot he skins surface, which makes the skin tingle and become more susceptible to stimuli.

To make the rubber flogger you will need...

A piece of wooden doweling – a section of broom handle is idea and inexpensive, a bicycle inner tube, rubber cement and some elastic bands.

First cut a piece of doweling to 14cm in length. Sand the end to get rid of any rough edges.

Cut a length of inner tube to 53cms, avoiding writing on the rubber. Then cut a straight line length-ways down the tube and open it out to a rectangle.

Cover the first 15cm of the rubber, (on the inside) with rubber cement. Place the piece of dowel onto the glued up rubber and hold it firm whilst it starts to stick. Then slowly roll the dowel along, rolling it up in the rubber. The other side of the rubber rectangle should overlap onto the first side.

Leave a small amount of overhanging rubber off the end of the dowel. This can be cut to size later once the glue is dry.

Wipe away any excess glue with a damp cloth.

Hold the rubber in place on the dowel by fixing a couple of elastic bands around to hold everything securely in place whilst the glue dries.

After a good 20 minutes or so, remove the elastic bands.

Re-apply glue to any edges that have not suck down properly the first time, and again hold everything in place with elastic bands. Leave overnight until all the glue had dried. In the morning remove the elastic bands, clean any excess glue away, and trim the overhanging rubber on the handle of the flogger.

At the other end of the flogger where there is a long surplus of rubber, carefully cut the rubber lengthways towards the handle to create tails. The rubber easily cuts with a sharp pair of scissors. Either cut chunky tails or skinny tails. If you do cut thinner tails you can add to the pain by tying a small knot at the tip of each tail, great for really naughty slaves.

It is always important during BDSM play to have a ‘Safety Word’. A safety word is a code that the submissive can use to mean, "Stop. I really mean it." The safety word should be agreed upon before play begins. When this word is used during games, all play must stop and everyone returns to normality. The word needs to be a word that you wouldn’t otherwise say during sexual intimacy; you don't want to use a word like "no" or "stop," because sometimes you might want to work a pretend struggle into your fantasy. If your scene involves gagging your partner, establish another way that that person can say "Stop" one common solution is for the gagged partner to hold a bell or some other object, and drop it if things get to be too much.

About the Author

More plans and step by step instructions for /www.sextoytesters.co.uk/home-made-sex-toys.shtml”>Homemade Sex Toys and other adult related naughtiness /www.sextoytesters.co.uk/home-made-sex-toys.shtml”>Click Here… and get crafting.